Connection With The Mains; Operation; Stand Alone Operation - EuroLite TC-300 Manual Del Usuario

The starting address is defined as the first channel from which the TC-200/TC-300 will respond to the
controller. If you set, for example, the address to channel 4, the TC-200/TC-300 will use the channel 4 to 6
for control.
Please make sure that you don't have any overlapping channels in order to control each TC-200/TC-300
correctly and independently from any other fixture on the DMX data link. If two, three or more TC-200/TC-
300 are addressed similarly, they will work similarly.
Occupation of the DIP-switches:

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the TC-200/TC-300 starts running. During the Reset, the motors
are trimmed and the device is ready for use within approximately 20 seconds.

Stand Alone operation

In the Stand Alone mode, the TC-200/TC-300 can be used without controller. You can do without a controller
as the TC-200/TC-300 features a built-in microphone, which provides automatic sound control.
Disconnect the TC-200/TC-300 from the controller and set all DIP-switches to Off.
International
L
N
26/55 00026917.DOC, Version 1.4