Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Quick Operation Guide
4.6 - The TL-A220, can also be used as a
conventional towerlift.
If you are using it as a conventional towerlift
always place the load as close to the body as
possible.
4.7 - Elevating the lift:
Once the Line Array is attached to its flying frame
and in the desired position on the forks it is ready
to be lifted to the required height. Turn the winch
handle in a clockwise direction to elevate the
lift.
The lifting carriage will rise first. When it reaches
the top the first section will rise along with the
other sections until the ligt has reached its
maximun height of 5,5 m.
The ILS and ALS enable the lift to automatically
block the carriage and profiles whilst rising
ensuring that it will never fall. The lift, with the
Line array attached will remain fixed at all times.
Once the system is elevated to its required height
gently turn the handle in a clockwise direction.
The security systems will ensure that the load
stays fixed and blocked. The red ALS locks will
be blocked. This enables the cable to be without
any force and means it is only used for the
elevation and descent of the lift.
The following instructions will help you to bring
the system down.
4.8 - Descending the lift:
To bring the lift down you need to first turn the
winch handle slightly clockwise and at the same
time pull out the red ALS lock in (G). (Fig. 7)
This releases the blocking systems. Then turn
the handle anti clockwise, whilst maintaining
the ALS lock pulled out in until the profile has
been completely lowered.
PRO LIFTS S.L.
ENGLISH
All red ALS locks should be pulled out one by
one whilst the handle is turned anti clockwise
and the profiles are brought down, one by one.
If you release your finger from the ALS lock it
will automatically block. In this case, repeat the
first operation by turning slightly clockwise and
then anti clockwise whilst always pulling the red
ALS lock in.
It is necessary to completely lower each profile
before starting to lower the next. If you push
another red ALS lock without having completely
lowered the previous profile the first profile will
remain blocked by the security system and you
will not be able to lower it later.
If this happens, elevate the towerlift to the
locked position and free the lock so that you
can commence the descent again until it is
completely lowered.
Finally, release the carriage lock following the
same principle as before and lower it to the
required level to be able to dismount the Line
Array from the lift.
4.9 - Transport
Once all the profiles are completely lowered
remove the FAS-01 or FAS-02 support and the
forks placing them in their horizontal position
facing down. Lower the carriage so that right
fork can be fixed and blocked for transport (B).
Remove the front support bars ( BA ) by taking
out the pins (BU). Replace the pins in the top
support ( E ) of the lift's base profile and also
at the top of each front support bar.
V.11.03 - Depósito legal y Copyright 2011. Todos los derechos reservados.
G
Fig. 7
Tabla de contenido
