Bestron AAC14000WF Manual Del Usuario página 51

3. Unscrew the rubber cap from the drainage hole
(figure 1-8), see also figure 5. The water flows
from the water collector into the bucket.
4. When the water collector is empty, put the
rubber cap back into the drain hole and make
sure it is tightly closed.
ATTENTION:
• Move the appliance carefully and always
vertically to prevent water from leaking over
the edge of the internal water collector. When
emptying, you can tilt the appliance slightly to
get the last water out of the water collector.
• If the bucket or other type of container cannot
collect all the water at once, replace the rubber
cap of the drainage hole in the meantime. Empty
the bucket and repeat the steps.
Continuous drainage
If you frequently use the device to dehumidify or cool air, you can also use the continuous discharge.
1. Switch off the appliance and unplug it.
2. Unscrew the rubber cap from the continuous
drain hole (figure 1-10), see also figure 6.
3. Connect a drain hose (not included) to the drain
hole (16 mm, figure 6) and make sure the end of
the hose ends in a drain, bucket or other type of
receptacle.
4. Use the device as indicated in this manual.
Cleaning and maintenance – Clean the filter
For optimal results, you should clean the 2 filters
every two weeks and replace them at least once
a year, or more often if the filter is visibly closed.
Also, clean the filter before storing the appliance for
extended periods of non-use or when returning it to
use after a longer period of time.
1. Switch off the appliance and unplug it.
2. Remove the filters at the top and bottom rear of
the appliance (Figure 7).
3. Rinse the filters with lukewarm water or soak in
warm soapy water.
4. Let the filters dry thoroughly.
5. Place the cleaned (or new) filters back into the
device.
ATTENTION:
• If the filters are not properly dried, water can get into the device. This can cause (electrical) damage.
51
EN
5
6
SCREW
7