Bestron AAC14000WF Manual Del Usuario página 48

Cooling
1. Press the "MODE" button (Figure 1-G) once or more times, until the indicator light "COOL" lights up. The
device will now function as an air cooler and will cool the air by means of a cooling element.
2. Use the "UP" (Figure 1-E) "DOWN" (Figure 1-F) buttons to set the cooling temperature between 16 °C
and 31 °C.
3. Press on the button "SPEED" (Figure 1-D) to switch between low or high speed for discharged air.
ATTENTION:
• When the internal water collector is full, the appliance stops operating and the indicator light on the
control panel lights up "FULL". You must empty the water collector before you can use the appliance
again (see 'CLEANING AND MAINTENANCE - Water drainage')
• If you frequently use the appliance to dehumidify or cool air, you can also use the continuous discharge
(see 'CLEANING AND MAINTENANCE - Water drainage').
USE - Sleep mode
The device is equipped with a sleep function. Enabling this function will allow the appliance to operate at its
quietest and most energy efficient setting
ATTENTION:
The sleep mode only works in the "COOL" mode.
1. Press the "SLEEP" button (Figure 1-H) to enable the sleep function. The device switches to the lowest
and most energy-efficient setting.
2. Press the "SLEEP" button again to disable the sleep function.
ATTENTION:
After switching off the sleep function, the device will remain in "COOL" mode.
USE
- Timer mode
The device is equipped with a timer that allows you to switch the device on or off automatically.
Automatic power-on
When the appliance is switched off:
1. Press the "TIMER" button (Figure 1-C). The display starts to flash.
2. Use the button UP/DOWN to set the switch-on time between 1 and 24 hours.
3. Wait for the displays to stop flashing. The switch-on timer is set.
4. Press the button again "TIMER" to adjust the switch-on time if necessary.
5. When the displays flash, press the button "TIMER" to turn off the timer.
Automatic power-off
When the appliance is switched on:
1. Press the "TIMER" button (figure 1-C). The display starts to flash.
2. Use the UP/DOWN button to set the power-off time between 1 and 24 hours.
3. Wait for the displays to stop flashing. The power-off timer is set.
4. Press the "TIMER" button again to adjust the power-off time if necessary.
5. When the displays flash, press the "TIMER" button to turn off the timer.
USE
- Remote control
The device can also be operated using the remote control included (figure 3). The remote control works
on two AAA batteries (not included). Open the battery compartment on the bottom, insert the batteries and
close the lid. The buttons on the remote control function the same as the buttons on the control panel.
For optimal use:
• Make sure the distance between the device and the remote control does not exceed 6 metres.
• Point the remote control at the device and ensure the direction angle is less than 30 degrees.
48
EN