Vibration Plate; Explanation Display Functions; Storage And Maintenance Surface Cleaning; Troubleshooting - Tunturi Cardio Fit V20 Manual Del Usuario

(Start/ Pause)
- Press the button to start the vibration plate�
- In the operation of the machine, press this button to stop working�
(speed+)
Speed increase: Manual 1- 30�
- Press this button to increase the speed when the machine is
operating�
(speed-)
Speed decrease: Manual 1- 30�
- Press this button to decrease the speed when the machine is
operating�
(time+)
Time increase:
The default working time is 10 Minutes, divided into 10 levels�
Press this button to Increase time� ( ± 1 minute )
(time-)
Time decrease: the default working time is 10 Minutes, divided into
10 levels�
Press this button to Decrease time�
Function
Control the three major functions of the vibration plate�
- Oscillation
- Vibration
- Oscillation/ Vibration combination
‼ NOTE
• The effective reception range of the remote Control signal is 2�5
meters, the infrared emission indicator of the controller should
be aligned the infrared receiving window on the vibration plate�

Explanation Display functions

Speed
- Displays current training vibration frequency setting�
- Range: 1 ~ 30�
‼ NOTE
• speed 1 = ± 430 Hrz p� min�
• speed 2 = ± 440 Hrz p� min�
• �����
• speed 29 = ± 710 Hrz p� min�
• speed 30 = ± 720 Hrz p� min�
Time
- Shows left time when workout�
Storage and Maintenance Surface
cleaning
⚠ WARNING
• Before cleaning, ensure the power switch is turned off, and the
attaching plug is pulled out of the socket�
- The rubber protective top mat and covers can be cleaned with
a wet cloth containing detergent, and the detergent should be
removed with a cloth notice
- Do not clean the vibration plate with corrosive detergent such as
benzene or thinner, as it may cause fading, corrosion or crack on
the vibration plate's shell�
- Do not splash water into the vibration plate to avoid short circuit�
⚠ CAUTION
• Do not carry this appliance by the power supply cord or use
cord as a handle�
Clean the remote controller
As wet cloth may cause malfunction of the controller, only dry cloth
can be used�
When cleaning the remote controller, it is recommended to take out
battery first�
Storage an Maintenance
- Make sure that the power switch is turned off and the plug is
removed From the power supply�
- Clean off the dust and dirt on the vibration plate and keep it clean
and away From places with high temperature or high humidity�
- If the vibration plate is not in use for along period, a dust proof
cover (buy it Yourself) should be applied on the vibration plate to
prevent the entry of dust�
Change of fuse: turn the fuse base in the direction of the arrow
(counter-clockwise), and replace the fuse with a clockwise screw back�
‼ NOTE
• Please consult after-sales department, if malfunction can not be
removed by consumers themselves

Troubleshooting

The vibration plate can not be started
- The plug is not in place, insert the plug to resolve�
- The power switch is in Off mode, Turn the power switch to ON
mode�
- Thermal fuse is burn, replace with a new fuse of the same model�
Sound like phew or Da-da is heard during working
- This is normal operational sounds produced by the motor of from
the abrasion between mechanical parts�
Operate the controller, but the vibration plate no action�
- The battery power of the remote is low, replace the battery to
resolve�
- The remote control is out of the receivers reach, make sure the
space in between the sender and receiver is not blocked and not
over 2,5 meters�
7
English