Support Bar Installation - OVE SHELBY-SP32 Manual De Instrucciones

SUPPORT BAR INSTALLATION

1-2. Install the glass panel's bracket (O) and the support bar's anchor (M) onto the support bar (N).
3. Mark the outline of the support bar's anchor (M).
4. Completely remove the support bar (N). Place the support bar's anchor (M) back on it's wall mark, mark the
hole of it.
5. Drill a hole on the center marks with a ø6mm (1/4in) drill bit.
6-7. Insert the wall anchors (FF) using a rubber mallet. Fix the center fitting on the support bar's anchor (M)
using the screw (DD).
8-9. Install again the support bar (N) onto the side panel (E) and support bar anchor (M). Strongly tighten the
bolts using Allen key.
1 2
N
N
M
O
E
4
3
M
5 6
Φ 6mm
FF
1/4in
9
7
8
N
O
DD
E
12