Cleaning; Reassembling Your Cushion After Cleaning - Ki Mobility Axiom SP Fluid Manual De Instrucciones

C. Cleaning
1. Cleaning the Covers
a. Remove the inner and outer cover from the foam base and zip closed.
b. Machine wash in warm water and tumble dry - no heat. Do not iron. Note - Do not dry
clean covers or use industrial washers and dryers to clean cover. Do not steam auto-
clave. Do not bleach.
c. To refit cover after washing, fit cover back over foam base. Ensure the back of the cover
matches up to the back of the foam base. Note - If utilized in an institutional setting,
write the residents name with a permanent marker on the content label of the cover. This
will ensure the return of the correct cover to its matching cushion after washing.
2. Cleaning the Foam Base
a. Remove the outer cover from the foam base and wipe lightly with a damp cloth. Do not
use soap. Do not submerge in water. Wipe off with a clean cloth.
b. Let your cushion completely air-dry before reassembly.
3. Axiom SP Fluid - Cleaning the Fluid Pad
a. Remove the cover from the foam base.
b. Remove fluid pad from the inner cover and wipe with warm water and soap.
c. Rinse with a clean, damp cloth. Dry with a clean cloth.
NOTE: Axiom SP Fluid - Never submerge the fluid pad in any liquid.
NOTE: Axiom SP Fluid - Avoid harsh cleaning or rough handling as this may lead to a
degradation of the fluid insert.
D. Reassembling Your Cushion After Cleaning
Axiom SP Visco
1. After Proper Cleaning and Maintenance
a. Insert the foam base into the inner cover with the label down and the zipper to the rear
of the cushion.
b. Insert base plus inner cover into the outer cover. Ensure that white inner cover label is
down and zipper is to the rear.
c. Close the zipper on your cushion ensuring that the zipper-pull ends up closed with the
pull tucked into the zipper pocket cover.
Viscoelastic Foam Insert
(Pre-installed)
Foam Cushion
Foam Cushion in
Inside Cover
Inside
Cover
Zipper fully
closed and
zipper-pull
tucked into
cover.
7
Outer Cover
Assembled
Cushion