Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A
ON (RESET)
With the lockout key in place and the
cover raised, the switch can be toggled
to the ON (RESET) position. Note that
the red slide panel is fully retracted
from the switch.
SWITCH OPERATION
This section explains the operation and features of
the switch prior to plugging the power cord into an
extension cord. The intent is to familiarize the user
with the switch operation without actually turning ON
the router.
The switch incorporates two positive features to
prevent inadvertent switching ON of the router and the
unauthorized, and possibly hazardous, use by others:
• There is a transparent cover over the actual switch
to prevent the accidental switching ON of the router.
This cover allows you to see a small red light on
the switch toggle when the switch is turned ON.
The switch can be turned OFF quickly by pushing
the cover.
• The light is ON when the switch is ON.
• The light is OFF when the switch is OFF.
• The lockout key must be completely inserted into
the side of the switch case before the switch can
be turned ON.
To operate the switch:
MAKE SURE THAT THE EXTENSION CORD IS NOT
PLUGGED INTO AN ELECTRICAL OUTLET BEFORE
PROCEEDING ANY FURTHER.
1. Insert the lockout key into the side of the switch
case. See Figure 17.
2. To turn the router ON, lift the switch cover and
toggle switch to ON (RESET) position. See A above.
Gently lower the switch cover. Letting the switch
cover drop closed may cause the switch to turn OFF.
3. To turn the router OFF, press the switch cover. The
switch toggle will be in the OFF position, as shown in
B above.
Router Table Operation
OFF
With the lockout key in place and the
cover raised, the switch can be
toggled to the OFF position. The
switch can also be turned OFF by
pressing on the cover. Note that the
red slide panel is fully retracted
B
OFF
ON (RESET)
from the switch.
UNATTENDED WHILE IT IS RUNNING OR BEFORE
IT COMES TO A COMPLETE STOP.
4. To lock switch in the OFF position, press the cover
to turn the switch OFF and remove the lockout key
completely from the side of the switch case. The red
slide panel should cover the top half of the switch, as
shown in C above.
With the lockout key removed and the red slide panel
covering the top half of the switch toggle, the switch
CANNOT be toggled to the ON position.
FIG. 17
SWITCH BOX
21
C
ON (RESET)
With the lockout key removed, the red slide
panel covers the top portion of the switch,
locking it in the OFF position. The switch
cannot be toggled to the ON (RESET)
position without first fully inserting the
lockout key.
NEVER LEAVE THE ROUTER
Switch receptacle orientation
(as viewed from front of switch)
Red slide
panel
OFF
LOCKOUT
KEY
Tabla de contenido
