HAMPTON BAY 52-NORD Guía De Uso Y Mantenimiento página 8

Assembly - Close-To-Ceiling Mount
1
Preparing for mounting
□
Remove canopy ring (JJ) from the canopy (C) by turning the
ring counterclockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by loosening the two canopy screws (HH) located in the "L
shaped" slots
□
Remove and save the two canopy screws (II) in the round
holes. This will enable you to remove the mounting bracket (A).
□
Remove the decorative canopy bottom cover (LL) from the
canopy (C) by pressing the three studs located inside the
bottom of the canopy.
HH
2
Routing the wires
□
Remove three of the six screws and lock washers (OO)
(every other one) securing the motor collar to the top of the
fan-motor assembly (E).
□
Route the wires exiting the top of the fan-motor assembly
(E) through the rubber gasket (FF) aligning the holes in the
rubber gasket (FF) with the three screw holes in the fan-
motor assembly (E).
□
Route the wires exiting the top of the fan-motor assembly
(E) through the canopy ring (JJ), and the canopy (C) (make
sure the slot openings for the canopy ring and canopy are
on top). Place the canopy (C) over the collar (MM) at the top
of the motor (E).
□
Align the mounting holes in the canopy (C) with the screw
holes in the motor (E) and fasten using the three screws
A
and lock washers (OO) (removed previously). Tighten the
mounting screws securely.
II
C
OO
JJ
LL
JJ
8
C
FF
MM
E