Maintenance - Sears Companion 919.329150 Manual Del Operador

120/240 voltios 5500 wats generador
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CUSTOMER RESPONSIBILITIES TABLE
MAINTENANCE TASK
Check oil level
Change oil
Clean Air Filter Assembly
Check Spark Plug
Prepare Unit for Storage
Note 1: Change oil after first two (2) operating hours and every 50 operating hours thereafter, more often if operated
in extreme dusty or dirty conditions.
Note 2: Check oil after 5 hours of operation (See the Oil paragraph on page 15 of this section)
GENERAL RECOMMENDATIONS
The warranty of the generator does not cover items
that have been subjected to operator abuse or negli-
gence. To receive full value from the warranty, opera-
tor must maintain the generator as instructed in this
manual.
Some adjustments will need to be made periodically to
maintain your generator.
GENERATOR MAINTENANCE
Your generator should be kept clean and dry at all
times. The generator should not be stored or oper-
ated in environments that include excessive moisture,
dust or any corrosive vapors. If these substances are
on the generator, clean with a cloth or soft bristle
brush. Do not use a garden hose or anything with
water pressure to clean the generator. Water may
enter the cooling air slots and could possibly damage
the rotor, stator and the internal windings of the
generator head.
All adjustments in the Maintenance section of this
manual should be made at least once each season.
ENGINE MAINTENANCE
NOTICE: Maintenance, replacement or repair of the
emission control devices and systems may be
performed by any nonroad engine repair establishment
or individual. However, to obtain no charge repairs
under the terms and provisions of the engine
manufacturers warranty statement, any service or
emission control part repair or replacement must be
performed by a factory authorized dealer.
D20498 Rev. 0 6/9/00

MAINTENANCE

Before each
Every 25
use
Hours of Every
Season
X
See Note 2
Prepare unit for storage if it is to remain idle for more than 30 days.
Oil
Oil level should be checked prior to each use and
at least every 5 hours of operation. To check oil
see Adding Engine Oil paragraph in the Operation
section on page 14.
Changing Engine Oil
For a new engine, change oil after the first 2 operating
hours. Thereafter, change oil after every 50 hours of
operation.
Change the oil while the engine is still warm. The oil
will flow freely and carry away more impurities. Make
sure the engine is level when filling, checking or
changing oil.
Change the oil as follows:
To keep dirt, grass clippings, etc. out of the
engine, clean the area around the drain plug and
dipstickbefore removing it.
Remove the oil drain plug and dipstick. Tilt the
engine slightly towards the oil drain to obtain
better drainage. Be sure to allow ample time for
complete drainage.
16 — ENG
Every 50
Hours of Every
Season
See Note 1
X
X
Every 100
Hours of Every
Season
X

Capítulos

Tabla de contenido
loading

Tabla de contenido