Bosch AQT 33-11 Manual Original página 11

OBJ_BUCH-2334-002.book Page 11 Wednesday, February 18, 2015 3:43 PM
The warning and information signs
attached to the unit provide impor-
tant information for safe operation.
Apart from the information in the op-
erating instructions comply with the
general safety regulations and regu-
lations for the prevention of acci-
dents.
Connecting to the mains
The voltage indicated on the rating

plate must correspond to the voltage
of the power source.
We recommend that this equipment

is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
Remove the plug from socket when-

ever the machine is left unattended
for any period.
The electric supply installation

should comply with IEC 60364-1.
If the supply cord is damaged, it must

be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
If the plug is damaged, pay attention

to the following:
Plugs and sockets situated near the

work site or outdoors should be to
class IP 55 of BS 5490 to provide ad-
equate protection against ingress of
water, etc. and cable entries require
effective sealing. Rubber shrouds
should be provided over cable
glands. Drip-proof (class IP X2 of
BS 5490) plugs and sockets to
BS 4343 are suitable for use indoors
where the plug is away from the water
Bosch Power Tools
spray area where the appliance is in
use.
Never touch the mains plug with wet

hands.
Do not pull plug while operating the

device.
Do not run over, crush or pull the

power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
Do not use the unit, if the power sup-

ply cord or important parts, e. g.
high-pressure hose, trigger gun or
safety devices are damaged.
Warning: Inadequate extension cords

can be dangerous.
If an extension cord is used, the plug

and socket must be of watertight con-
struction. The extension cord must
have a cross section in accordance
with the operating instructions and
be protected against splashed water.
The connection must not be in water.
When replacing plugs on the power 
supply cable or extension lead the
spray water guard and mechanical
stability must remain intact.
Water connection
Comply with the regulations of your

water supply company.
All connecting hoses must have prop-

erly sealed joints.
Make sure that the supply hose is at
 least 12.7 mm (1/2") in diameter and
is reinforced.
The appliance should never be used

on the drinking water supply without
a back flow valve. Water which has
English | 11
F 016 L81 121 | (18.2.15)