Appendix B Error Codes - Nedap PR30S Manual De Instalación

Appendix B Error codes

Solar-related error codes
Error code on display Error cause
S002-S Over temperature in Solar module
S004-S Solar panel voltage too high
S007-S Solar panel current too high
S005-S An internal bus problem
S013-S Solar panel power output too high
S016-S Internal communication error
grid-related error codes
Error code on display Error cause
D001-S Grid module temperature too high
D002-S An internal bus problem
D003-S
D007-S Grid relay failure
D007-H
D010-S Internal overload
D015-S Internal communication error
D025-H An internal bus problem
D027-H
D028-H Internal supply voltages out of range
D029-S Cold start failed
D011-S Load voltage too low
D012-S Load voltage too high
D013-H Load short circuit
D023-H Current overload
D031-H Power overload
System-related error codes
Error code on display Error cause
P027-H Internal voltage error
P028-H Internal frequency error
P029-H Internal relay error
P089-H Self-use sensor not found
P092-H The PowerRouter is not configured
P098-H Hardware is not supported in software
P081-H Install wizard error
User recommended action
Check ambient temperature of the PowerRouter. Check for
obstructions in the air flow channel.
Check solar panel configuration and wiring
Contact your installer/dealer if this fault occurs frequently
User recommended action
Check ambient temperature of the PowerRouter. Check for
obstructions in the air flow channel.
Contact your installer/dealer if this fault occurs frequently
Check grid voltage
Check load
Disconnect excessive loads
User recommended action
Contact your installer/dealer if this fault occurs frequently
Reset the PowerRouter, re-run the Install Wizard
EN
15