Functional Description - Makita GD0600 Manual De Instrucciones

7. Make sure the wheel is not contacting the work-
piece before the switch is turned on.
8. Before using the tool on an actual workpiece, let
it run for a while. Watch for vibration or wobbling
that could indicate poor installation or a poorly
balanced wheel.
9. Watch out for flying sparks. Hold the tool so that
sparks fly away from you and other persons or
flammable materials.
10. Do not leave the tool running. Operate the tool
only when hand-held.
11. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
12. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high loca-
tions.
13. Do not use water or grinding lubricant.
14. Do not use this tool as cutter.
15. ALWAYS wear proper apparel including long
sleeve shirts, leather gloves and shop aprons to
protect skin from contact with hot grindings.
16. Use of this tool to grind or sand some products,
paints and wood could expose user to dust con-
taining hazardous substances. Use appropriate
respiratory protection.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.
SYMBOLS
The followings show the symbols used for tool.
V............................volts
A ...........................amperes
Hz..........................hertz
....................alternating current
.......................no load speed
.......................Class II Construction
.../min....................revolutions or reciprocation per
minute

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch lever actuates properly and returns
to the "OFF" position when released.
• Do not pull the switch lever forcibly without pushing
in the lock-off lever.
To prevent the switch lever from accidentally pulled, a
lock-off lever is provided. To start the tool, pull the lock-off
lever toward the operator and then pull the switch lever.
Release the switch lever to stop.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing wheel point
USD201-2
1
2
3
Loosen the collet nut and insert the wheel point into the
collet nut. Use one wrench to hold the spindle and the
other one to tighten the collet nut securely.
The wheel point should not be mounted more than 8 mm
(5/16") from the collet nut. Exceeding this distance could cause vibration or a broken shaft.
To remove the wheel point, follow the installation proce-
dure in reverse.
4
007126
2 3
1
007055
1. Switch lever
2. Lock-off lever
3. Cap
1. Wrench 13
2. Collet nut
3. Wrench 13