Cleaning And Care; Replacing The Light Bulbs - Siemens LF 157 GA 70 Instrucciones De Uso Y Montaje

Cleaning and care

Isolate the extractor hood by pulling out
the mains plug or switching off the fuse.
Do not clean the extractor hood with abrasive
sponges or with cleaning agents which
contain sand, soda, acid or chlorine!
Clean the extractor hood with a hot soap
solution or a mild window cleaner.
Do not scrape off dried-on dirt but wipe off
with a damp cloth.
When cleaning the grease filters, remove
grease deposits from accessible parts of
the housing. This prevents the risk of fire
and ensures that the extractor hood
continues operating at maximum efficiency.
Note: Do not use alcohol (spirit) on plastic
surfaces, as dull marks may appear.
Caution: Ensure that the kitchen is ade-
quately ventilated. Avoid naked flames!
Clean the operating buttons with a mild
soapy solution and a soft, damp cloth only.
Do not use stainless-steel cleaner to clean
the operating buttons.
Stainless steel surfaces:
Use a mild non-abrasive stainless steel
cleaner.
Clean the surface in the same direction as
it has been ground and polished.
We recommend our stainless steel cleaner
no. 461731. See enclosed service booklet
for order address.
Aluminium and plastic surfaces:
Do not use dry cloths.
Use a mild window cleaning agent.
Do not use aggressive, acidic or caustic
cleaners.

Replacing the light bulbs

Switch off the extractor hood and pull
out the mains plug or switch off the
electricity supply at the fuse box.
Replace faulty lights through new ones
immediately.
Please cut the connection between the
extractor hood and the power supply system!
The lightings remain hot for some time.
Please wait therefore for some time till the
lightings have cooled off.
After cooling-off the glass cover is to be
removed with a small screwdriver. Then the
lighting can be taken out. Please avoid any
skin contact with the luminous means. After
the exchange press the glass pane lightly
to a certain extent (lock in of the pane).
Restore the power by inserting the mains
plug or switching on the fuse.
Note: If the light does not function, check
that the bulbs have been inserted correctly.
en