Charging The Battery; Using A Micro Sd/Sdhc Card; Transfer Of Data Between Device And Computer - Intenso TAB 1004 Manual Del Usuario

5.) Charging the battery

Fully charge the battery of the device before using it for the first time. To this end connect the
supplied power cable with the device and a socket. The complete charging process takes about 5
hours. The charging status is displayed at the front left side of the device. The LED lights up Red
during the charging process, and changes to Yellow as soon as the battery is fully charged.
Notes
a. With 15% remaining residual power of the battery you will get a warning message on the display. To recharge the battery, you
should now connect the device using the AC adapter to an electrical outlet to avoid possible data loss and increase the battery life.
b. You can use the device while charging the battery. To ensure long-lasting battery life, we ask you not to use the device.
c. To ensure good performance, the built-in battery must be used frequently. If you use the device often, please charge the battery
fully at least once a month.
d. Make sure you use only the included AC adapter for charging.

6.) Using a Micro SD/SDHC Card

This device can read data directly from a Micro SD/SDHC card with a maximum capacity of 32 GB.
To use a Micro SD/SDHC card, please insert the card in the designated Micro SD Slot on the left
side of the device. Use the pre-installed Explorer to access the data on the memory card. To do
that, please select the directory "SD Card" in the Explorer.

7.) Transfer of Data between Device and Computer

1.) Connect the device using the included USB cable to a computer. Should the device not have been
previously switched on, it will start automatically. This may take a moment, because the operating
system must first boot up. If device was already switched on, the computer should automatically
detect it within a few seconds.
2.) On the device the screen for the USB connection is now displayed. Tap briefly "Turn on USB
Storage". The device is recognized as a removable disk and you get the info "USB memory in use".
After briefly tapping the home button you can continue to use your device normally. You have now
have access to the internal memory of the device from your computer and can copy, delete or
transfer files to your device.
3.) If an USB connection with the computer exists, the USB icon is displayed in the status bar. You can get
additional information in the extended status bar (click on the clock in the status bar to open it) and you
can activate or deactivate the USB connection.
EN - 5