Maxtec Blender Buddy Manual Del Usuario página 6

Ocultar thumbs Ver también para Blender Buddy:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
INSTRUCTIONS FOR USE
Before assembly verify that the flow meters are the correct flow and gas type according
to the labeling on the flow meters. Prior to assembling the Blender Buddy inspect all
parts for signs of damage.
1. Be sure the small o-ring
between the small block
2. Attach the small adapter block
and provided Allen Wrench (No thread tape is necessary). Remove any fittings
H
from the left side outlet if necessary.
*Skip to Step 9 if flow meters are already attached.
3. Wrap both threaded ends of the pipe nipples
Use caution to ensure tape does not occlude the fittings.
4. Use a 7/16" wrench to tighten the pipe nipples
flow meters
5. Tighten one assembled flow meter
block
. Use caution to ensure the flow meter is mounted vertically.
A
6. Remove the clear flow tube and shield from the other flow meter
the flow meter components are arranged for reassembly in a subsequent step. Use
caution to prevent contamination from entering the disassembled flow meter.
7. Tighten the disassembled flow meter
large block
A
8. Reassemble the flow meter
vertically.
9. Insert large o-ring
10. Verify white bleed control plug is inside port of the large block.
11. Attach large block
12. Supply gas to the blender and check for leaks and proper function.
NOTE:
The blender buddy is designed for use on the primary port (left side) of a blender.
The blender buddy has a 3 lpm continuous bleed built into the manifold of the device.
When properly installed on the left side of a blender the blender buddy's bleed ensures
accuracy of flow from the primary port at low flow rates, i.e. less than 3 lpm and is equal
to the low flow accuracy of the auxiliary port on the right side of the blender.
4
D
is present around the threads of the short bolt
and the blenderr.
B
.
G
F
.
. Use caution to ensure the flowmeter is mounted
F
into o-ring groove of the large block
I
to small block
A
866.4.Maxtec
B
to the left side of the blender using the short bolt
with thread tape (1-1/2 wraps).
E
E
G
into one of the threaded holes on the large
into the other threaded hole in the
F
with the two long screws
B
www.maxtec.com
into the threaded holes of the
F
. Note how
A
.
C
H
.
Tabla de contenido
loading

Productos relacionados para Maxtec Blender Buddy

Este manual también es adecuado para:

R219p18

Tabla de contenido