Connections - RIDGID SeeSnake Serie Manual Del Usuario

SeeSnake
The Monitor Pack can be tilted to several different viewing
angles. When a battery is installed, it can be tilted to rest on
its rear supports (Figure 11) . The front handle attached to
the monitor shield can also be used as a tilt stand (Figure
5). Grasp the Monitor Shield Release Lever (Figure 4) , pull
it toward the handle to release the Monitor Shield, and ro-
tate the monitor shield down (Figure 5).
Figure 11 – Monitor Pack Tilted Using Rear Supports
TIP: In brightly lit areas, point the monitor screen away
from bright light sources to reduce glare.

Connections

Connect the Monitor Pack to an AC outlet using the
supplied AC adapter. If desired, you can install an op-
tional Makita ® 14.4V rechargeable battery into the battery
holder on the rear of the unit instead of using the AC
adapter (Figure 12).
If the AC adapter supplied is a universal type with de-
tachable power cord, use only cord with Class II IEC
60320 connector and mains plug approved for the coun-
try where unit is used.
Figure 12 – Battery Holder
NOTE! The Monitor Pack will not recharge the battery;
the battery must be removed from the Monitor
Pack for recharging. Use only the charger spec-
ified by the battery manufacturer.
8
® Compact and Color Compact
Unwrap the Interconnect Cord from its holder on the
frame and plug its connector into the matching connector
on the Monitor Pack. To join the connectors, position the
Interconnect Cord connector so the red arrow is facing up,
push the connector straight in and tighten the locking
sleeve (Figure 13).
Figure 13 – Tightening the Locking Sleeve
If the connector does not push in easily, align the guide pin
on the Interconnect Cord's connector to the guide socket
on the Monitor Pack's connector (Figure 14).
Guide Socket
Figure 14 – Guide Pin on the Interconnect Cord
NOTE! Twist only the outer locking sleeve! Bending or
twisting the connector body inside the locking
sleeve will damage the connector. When unplug-
ging you may wiggle a little, if necessary, but do
not bend or twist.
Locking Sleeve
Guide Pin