Cembre HT81-U Manual De Uso Y Mantenimiento página 5

ENGLISH
2.6) Die replacement
(Ref. to Fig. 2)
– Press release pin (27) and withdraw die stop pin (22).
– Remove dies from head and insert replacement dies.
– Insert die stop pin (22) until fully located.
Before carrying out further operations make sure the die stop pin (22) is completely inserted; a partial
insertion may cause damage to the head.
3. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance of the tool.
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day after use, the tool must be wiped with a clean cloth, taking care to remove any residue,
especially close to pivots and moveable parts.
3.2) Storage
(Ref. to Fig. 3)
When not use, the tool should be stored and transported in the case, to prevent damage.
Type VAL-P3 plastic case is 620x380xh135 mm (10.6x3.1x1.2 in.) and weights 2,5 kg (5.5 lbs);
Type VAL-75 is smaller and holds up to 5 sets of dies is available as an optional extra.
3.3) Head rotation
For ease of operation, the tool head can rotate through 180°.
Warning: do not attempt to turn the head if the hydraulic circuit is pressurised.
5