Installation And Use; Safety Instructions; Use - Casselin CFP10TB Manual De Instrucciones

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Risk from electrical current!
• No contact with heat sources must take place with the power cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water in the unit in operation or still hot.
• The device must be connected properly and comply with regulations.
WARNING
By operating the apparatus may reach high temperatures. To avoid burns and accidents, do not use the
machine malfunction and do not use spare parts that do not origins.
ELECTRICAL HAZARD
Risk from electrical current!
In case of improper installation, the device can be dangerous and cause injury. Before installation, check the
power system data. Connect the device only when there is compliance. The unit should be unpacked and
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
The unit must be completely removed from its packaging. All guards must be completely removed.
Place the machine upright on a solid, flat surface Never professional fryer up on a flammable surface.
Do not install this device near open fires or other heating appliances.
Thoroughly clean the appliance and accessories. Do not use abrasive products.
The device must be plugged directly into a wall outlet. Using a power strip will crack up the device.
The device must be placed with a 10 cm safety distance with the wall.
Check there is no water in the oil pan and then pour oil into the tray. Two pins are included in the oil pan. The
minimum and maximum amounts are to be observed. It is recommended to use quality oil, less saturated fat
vegetable oils are recommended. (When using solid shortening, have it always melt before adding it to the
frypot)
Electrical connection: Installation and commissioning unit into operation must be performed by personnel
with the skills necessary for this purpose and conducted in compliance with the applicable standards of
accident prevention. Ensure make the connection in compliance with the data on the data label. The power
outlets must be near the appliance and be easily accessible. If this equipment is wired directly to the power
supply, it is necessary to incorporate a power cut-off means with separation of the contacts at least 3 mm for
all poles.
Change the oil regularly. After cooling of the fryer and oil, carefully pour oil
used in the recovery vessel and evacuate respecting environmental protection rules.
Check that the device is turned off and connect the device once the oil level reached, never
turn on the unit with a level not reached oil. Once connected the green light
lights.
EN