Installation And Use; Safety Instructions - Casselin CFIV8 Manual Del Usuario

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
5.2 Installation and use
WARNING
The set-up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
The device must be completely removed from its packaging. All protections must be completely removed.
Place the appliance upright on a solid, flat surface. Never stand the professional fryer on a flammable
surface.
Do not install this appliance near open fires, or other heating appliances.
Carefully clean the device and its accessories. Do not use abrasive products.
The device must be plugged directly into a wall outlet. Using a multiple socket will cause the device to trip.
The device must be placed with a safety distance of 10 cm from the wall. Check that there is no water in
the oil pan then pour oil into the pan. Two marks are inscribed in the oil pan. The minimum and maximum
quantities must be respected. It is recommended to use a quality oil, vegetable oils less saturated with fats
are recommended. (When using solid vegetable fat, always melt it before adding it to the frypot).
Electrical connection: the installation and commissioning of the device must be entrusted to personnel
possessing the necessary skills for this purpose and carried out in compliance with the standards in force in
terms of accident prevention. Make sure that the connection is made in accordance with the data on the
technical characteristics plate. The power outlets must be located near the device and be easily accessible.
If this equipment is wired directly to the power supply, a means of disconnecting the power supply must be
incorporated with contact separation of at least 3mm for all poles.
Change the oil regularly. After the fryer and the oil have cooled down, carefully pour the used oil into the
collecting container and dispose of it in accordance with the rules for the protection ofthe environment.
Connect the appliance once the oil pan is filled to the desired level between MIN and MAX or up to the
MAX mark (Never be above the MAX mark and below the MIN mark).
EN