Sharp PN-V600A Manual De Instalación página 8

Connections
■ Connection with RS-232 cable
If you connect the monitor in a daisy chain using RS-232
cable, using the monitor buttons on the primary (main unit),
settings are copied to the secondary (expansion unit) and
operation from the primary can perform operation for all
monitors. Setting each ID No. in the monitor is required.
The first monitor will be set as primary (main unit) and the
second monitor and beyond will be secondaries (expansion
units).
Connect the RS-232C cables in order, starting with the first
monitor (primary monitor). If monitors are connected in a
different order they may not be operable.
First monitor: primary
RS-232C
RS-232C
output terminal
input terminal
RS-232 straight cable
(commercially available)
Connect the third monitor and other monitors in the same
manner.
Up to 25 monitors can be connected. (Depending on the
length of the cable used and the surrounding environment.)
ID Number is set with the primary monitor's buttons. If you set
AUTO ASSIGN ID No., located in the menu of the monitor to
ON, the ID No. will be automatically assigned in order from the
primary.
■ Connection with the control kit (optional)
If performing operation of the monitor with the remote control
unit, the PN-ZR01 control kit (optional) is required.
Attach the remote control sensor box as shown in the following
illustration. (Right side recommended)
For the monitor in
landscape orientation
Caution
• When attaching the remote control sensor box, turn the
main power switch OFF.
• Connect the monitors together in a daisy chain with RS-232
cable.
6
E
Second monitor: secondary
RS-232C
output terminal
Third monitor: connects to secondary
RS-232C input terminal
For the monitor in
portrait orientation
1. Insert the anti-rotation protrusion of the mounting
bracket into the anti-rotation hole of the monitor.
2. Secure the stand angling hole of the monitor with the
mounting screw.
3. Adjust the angle of the remote control sensor box, and
secure it with the fixing screw, so that it may accurately
receive signals from the remote control unit.
Stand angling hole
Remote control
sensor box
Angle
adjustment
Fixing screw
Mounting screw (short)
4. Insert the remote control sensor box connection cable
into the control kit terminal.
Control kit terminal
Installing the batteries
1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
batteries (R-6 ("AA" size) x 2) (supplied with the PN-ZR01
(optional)) with their plus (+) and minus (-) sides oriented
correctly.
3. Close the cover.
Anti-rotation hole
Anti-rotation protrusion
Mounting bracket
Remote control
sensor box
Connection cable