Mounting The Charger On A Wall; Led Diagnostics; Leds On The Battery; Battery Status - Stihl BGA 57 Manual De Instrucciones

12 LED Diagnostics

To charge the battery:
2
1
► Push the battery (2) into the charger (3) until it stops.
The LED on the charger (4) glows green when the battery
is charging.
The LEDs (1) on the battery glow green and show the
state of charge.
When the LEDs on the battery turn off, the charging
process is complete and the charger will shut itself off.
► Remove the battery from the charger and disconnect the
power supply cord from the wall outlet when charging is
complete.
A battery is not fully charged when it ships from the factory.
STIHL recommends that you fully charge the battery before
using it the first time.
Operate the charger only indoors, in dry rooms and within an
ambient temperature range of 41 °F to 104 °F (5 °C to
40 °C).
The battery heats up during operation of the blower. If a hot
battery is inserted into the charger, it may be necessary for
it to cool down before charging starts. The charging process
begins only after the battery has cooled down sufficiently.
Charging time depends on a number of factors, including
battery condition and the ambient temperature. For a
complete list of approximate charging times, see
www.stihl.com/charging-times.
0458-807-8621-A
3
4

11.3 Mounting the Charger on a Wall

When mounting, ensure that no electrical cables, pipes or
other service lines run in the wall behind the charger.
To mount the wall charger:
1 2
a
b
a
► Mount the charger indoors in a dry room near a wall outlet.
► Sink the screws into a wall stud. Use appropriate screw-in
wall anchors or other similar mounting devices if an
appropriate wall stud is not available.
► Align the charger as shown above. Mount to a wall with the
following dimensions:
– a = minimum 3.9 in. (100 mm)
– b (for AL 101) = 3.0 in. (75 mm)
– b (for AL 300 and AL 500) = 4.7 in. (120 mm)
– c = 0.2 in. (4,5 mm)
– d = 0.4 in. (9 mm)
– e = 0.1 in. (2,5 mm)
12 LED Diagnostics

12.1 LEDs on the Battery

12.1.1 Battery Status

Four LEDs show the status of the battery. These LEDs can
glow or flash green or red.
English
3
d
e
e
17