Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ImPORTANT:
Do not over bend the support rods during
the following step. Over bending will cause the steel rods
to loose supporting tension.
10. (Figure 17) Tip the hopper onto it's back to assemble
the two hopper support rods. Place the ends of each
rod into the upper and lower rear hopper tubes, bending
the rod just enough to fit into the holes in the tubes.
11. (Figure 18) Insert a 3/8" x 3" clevis pin (R) through
the lower hole in each upper hopper side tube. Next
assemble a bag arm tube onto each clevis pin and
secure it with a 3/32" hair cotter pin (N).
12. (Figure 18) Assemble a vinyl cap (V) onto the end of
each bag arm tube.
LOWER HOLE
VINYL CAP (V)
SUPPORT
RODS
3/32" HAIR
COTTER PIN (N)
3/8" x 3"
CLEVIS PIN (R)
BAG ARM TUBE
ENGLISH
13. (Figure 19) Secure the rope to the top center of the
hopper bag frame.
17
14. (Figure 20) T o assemble the hopper bag to the sweeper,
slide the ends of the bag arm tubes into the ends of the
sweeper's hitch tubes and secure with two 1/4" x 1-3/4"
clevis pins (Q) and 3/32" hair cotter pins (N).
18
10
BAG ARM TUBE
1/4" x 1-3/4"
3/32" HAIR
CLEVIS PIN (Q)
COTTER PIN (N)
19
20
Tabla de contenido
