Air Supply - Napa 6-745A Manual De Instrucciones

AIR SUPPLY

Tools of this class operate on a
wide range of air pressures. It is
recommended that air pressure of
these tools measures 90 PSI at the
tool while running free. Higher
pressure
(over 90 psig; 6.2 bar)
performance beyond the rated
capacity of the tool, which will
shorten tool life because of faster
wear and could cause injury.
LUBRICATION
Lubricate the air motor daily with
quality air tool oil. If no air line
oiler is used, run a teaspoon of oil
through the tool. The oil can be
squirted into the tool air inlet or
WARRANTY POLICY: NAPA PROFESSIONAL AIR TOOLS are warranted against defects in material and
workmanship for a period of one (1) year from the date of the original purchase. We will repair or replace
at our option any defective part or unit which proves to be defective in material or workmanship during
this one year period. ALL NAPA PROFESSIONAL AIR TOOLS must be repaired only by authorized NAPA
PROFESSIONAL AIR TOOL Service Centers. This warranty does not cover damage to tools rising from
alteration, abuse, misuse and does not cover any repairs made by anyone other than an authorized NAPA
PROFESSIONAL AIR TOOL Warranty Center. Tools sent to a Warranty Center in a dissembled condition will
not be covered as a warranty repair.
Return tools to Service Centers transportation prepaid. Be certain to include your name, address and
phone number along with proof of purchase information, with each tool.
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE.
6-745A
Always use clean, dry air. Dust,
corrosive fumes and/or water in the
air line will cause damage to the
tool. Drain the air tank daily. Clean
the air inlet filter screen on at least
raises a weekly schedule. The
recommended hookup procedure
can be viewed in the above figure.
The air inlet used for connecting
air supply, has standard 1/4" NPT.
into the hose at the nearest
connection to the air supply, then
run the tool. The oil plug is
ONLY for adding standard SAE
10 or 20 grade oil after repair or
Line pressure should be increased
to compensate for unusually long
air hoses (over 25 feet). Minimum
hose diameter should be 3/8" I.D.
and fittings should have the same
inside dimensions and be tightly
secured.
maintenance. The amount of oil to
be used is 1 ounce. Overfilling will
cause a reduction in the power of
the tool.
3 Rev. 05/27/05