Care And Cleaning - Osterizer 250-22 Manual De Instrucciones

TOGGLE MODELS
1. Push switch up and blend ingredients to desired consistency.
2. Push switch to the off "O" position to stop the blender and turn blender off.
3. To use PULSE, push switch down for desired length of time.
4. Release PULSE and allow blade to stop. Repeat cycle as desired.

CARE AND CLEANING

Blender jar parts are corrosion resistant, sanitary and easily cleaned. Before first use and after
every use, separate jar parts and clean thoroughly in warm, soapy water, then rinse and dry
well. DO NOT WASH ANY PARTS IN AN AUTOMATIC DISHWASHER.
Periodically check all parts before re-assembly. If the processing blades are stuck
or difficult to turn, DO NOT USE BLENDER. Check by carefully turning the blades
in a counterclockwise direction (opposite edges are sharp). Blades should turn freely.
If the jar is chipped or cracked, DO NOT USE BLENDER. Further use could result in the
jar breaking during use. Use only OSTERIZER Blender recommended replacement parts
®
available at an Authorized Service Center.
USE OF DAMAGED OR NON-RECOMMENDED PARTS COULD RESULT
IN SEVERE PERSONAL INJURY AND/OR DAMAGE TO THE BLENDER.
See Page 4 for proper jar assembly and user instructions.
NEVER IMMERSE THE MOTOR BASE IN WATER. The housing can be cleaned
with a damp cloth (unplug first). The motor is permanently lubricated and does not require
any additional lubrication. ANY SERVICING SHOULD BE PERFORMED BY AN
AUTHORIZED SERVICE FACILITY.
E ng li s h - 7