NEC MultiSync LCD1990SXi Manual Del Usuario página 6

Quick Start
Figure 4
Highest
Stand
Position
DVI-D
DC-OUT
(DC out for optional NEC products such as
the Soundbar attachment. Do not use this
connector unless specified.)
Make sure to leave enough slack in the cables so that the Tilt and the
Raise and Lower functions of the monitor are not impeded.
6. Hold all of the cables firmly and place the cable cover onto the
stand (Figure 8).
7. Slide the Cable Cover back into its correct position (Figure 9).
Connect the power cord to power outlet.
NOTE: Please refer to the Recommended Use section of this manual for
proper selection of power cord.
8. The vacation switch on the left side of the monitor must be in the
ON position for the monitor to function (Figure 0).
Turn on the monitor using the front power button, then turn on the computer.
NOTE: The Vacation Switch is a true on/off switch. If this
switch is in the OFF position, the monitor cannot be
turned on using the front button.
DO NOT turn the vacation switch ON/OFF repeatedly.
9. For Analog input only: Upon initial setup, the No-Touch Auto Adjust feature
automatically adjusts the monitor to the optimal settings that are needed for
most signal timings.
For further adjustments, refer to the Controls section of this User's Manual
for a full description of the OSM controls.
For download information on the Windows
your monitor, visit www.necdisplay.com/support.
NOTE: If you have any problems, please refer to the Troubleshooting
section of this User's Manual.
– continued
30 Tilt
DVI-I
D-SUB
Power cord
95/98/Me/2000/XP INF file for
®
4
Figure 5
Figure 6