Other Features - Krups SAVOY EC313 Manual Del Usuario

KR_CAFETIERE_SAVOY_EC313_NAFTA_NC00131759_Mise en page 1 10/09/15 09:49 Page10
■ Add 1 KRUPS spoon (w) of ground coffee per cup. Do not exceed 12 spoons (2 ounces). Fig. 10.
■ Close the lid (b).
■ Press the brew button (l). The BREW button light will come on to show that the coffee maker has started
the brew cycle. The machine will beep once. Fig. 11.
■ Once the cycle has finished, the keep warm function will switch on automatically. At the end, your machine
will beep 3 times and the brew button (l) will turn off.
NB:
- The amount of coffee in the carafe at the end of the cycle is less than the amount of water poured into the
tank because about 10% is absorbed by the ground coffee and the filter.
- There is an overflow hole on the back of the water tank. If you add too much water, it will leak out of this hole.
- Clean the permanent filter between each use or use a new paper filter.
- The tip Aroma Tube (h) of the carafe is removable. You can use your coffee maker without Aroma Tube.
CAUTION:
- To avoid any overflow, the carafe must be properly positioned on the warming plate of the
coffee maker, otherwise it could cause hot water or hot coffee to overflow.
- The coffee maker becomes very hot during the brew cycle. Please handle with care.

6. OTHER FEATURES

6a – AUTO START FUNCTION
Programming the auto-start settings.
■ Your appliance is equipped with auto-start program.
■ Check whether the clock is set to the right time. If not, follow the instructions in the SETTING THE CLOCK
section.
■ Press the AUTO ON (m) button. The AUTO icon will appear on the display. Figs 12-13-14.
■ Set the time by pressing the H button (n) to set the hour and the MIN button (o) to set the minutes.
Set the program by pressing BREW (l).
■ Starting a auto-on function when time has already been set.
- See the section MAKING COFFEE.
- Press AUTO ON, then press BREW (l).
■ To cancel the auto-start function, press twice the AUTO ON button or press the BREW button.
6b – REGULAR OR BOLD
■ The BOLD function increases the cycle time for stronger coffee.
■ Press the BOLD (p) button to select the strength of your coffee. Fig. 15.
■ The BOLD button lights up (p).
■ The function is stored in the memory for subsequent cycles.
■ To cancel the BOLD function, press the BOLD button again.
6c – 1 - 4 CUPS
■ This function is specially designed for making small volumes of coffee, i.e. between 2 and 4 cups. It makes
it easier to extract optimal aroma and flavor.
■ To activate this function, press the 1 - 4 cups button (q) before starting the cycle. Fig. 16.
■ The 1 - 4 CUPS button lights up.
■ To cancel the 1 - 4 cups function, press the 1 - 4 CUPS button again.
6d – KEEP WARM
TIME
■ By default, the keep warm function on your appliance is preset to 2 hours
■ To cancel the keep warm function, press KEEP WARM (r); the light on the button will turn off.
10