Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CLEANING
•
Clean the lamp with a damp cloth. Do not use detergents or any other chemical products as they could
damage the lamp's cover.
•
Do not expose the charger to water.
ELECTRICAL DATA
CHARGER :
100~240V AC, 50–60 Hz — 7,5V DC, 600mA
BATTERY :
Li-Po, 3,7V, 3000mAh
INFRARED REMOTE CONTROL
USE
Ensure there are no obstacles between the infrared signal of the
remote control and the lamp. Infrared is susceptible to interference
from other devices so its use will be easier outdoors than indoors. It
can be used at a distance of between 1 and 5 metres from the LED
lamp, according to surroundings.
NOTE
•
Before using the remote, remove the plastic tab from the bat-
tery compartment.
•
If the remote doesn't appear to be working after you have pu-
shed the buttons several times, put it down for 1 minute, then
move nearer to the lamp and begin again.
•
The remote can be used on more than one lamp but you will
need to be closer to the lamp than normal in order to ensure
you are changing the correct lamp.
•
Indoors, due to interference from other domestic appliances, it
may be difficult to use the remote from a distance of 5m. If so,
get nearer to the lamp.
Remote control reference
Remote control frequency
20/11/2019
R
REMOTEAG01 (SW-RM001)
38MHz
OFF
ON
G
B
W
FLASH
STROBE
FADE
SMOOTH
15
EN
Tabla de contenido
