Important Safety Instructions - Kodak Ektalite E10 Instrucciones De Operación

Important Safety Instructions

Read all instructions before using the projector.
Follow the safety instructions below when using the over-
head projector.
• Do not allow children to operate this unit.
• Do not touch hot parts near the lamp housing.
• Do not operate a damaged unit or disassemble the unit by yourself.
• Use a qualified service technician when repair is required. Incorrect
assembly can cause electric shock.
• Keep the power cord away from hot surfaces. If the power cord is dam-
aged have it repaired before using.
• If it is necessary to use an extension power strip, use one which is fuse
and safety certified.
• Disconnect the power plug when not in use. Pull on the plug, not the
cord, when disconnecting from the power source.
• Make sure the unit is completely cooled before storage.
• Place the projector on a flat and stable surface.
• To prevent electric shock, do not operate the unit if it is wet or on a wet
surface.
• Disconnect the power cord from the power source before removing the
lamp.
• Do not touch the projection lens while the lamp is on.
• Do not obstruct the ventilation area.
• Always open the projection head before operating the unit. Trapped heat
can cause mirror damage.
• Do not look directly at projected light to prevent eye damage.
• Do not use the unit for purposes other than projection of transparencies
or LCD panels.
• Use only the lamp as indicated on the label inside your projector. Use of
improper lamp can result in damage or poor performance.
14
KODAK EKTALITE E10/E11/E12 OVERHEAD PRO-