Tabla de contenido
INSTALLATION IN DETACHED HOUSES WITH 2 POINTS OF ENTRY
PROGRAMMING INSTRUCTIONS
The programming of the connections bracket must be carried out from the entrance panel which is configured as the main panel of
the system (with J1 jumper in place: see wiring diagram on page 8).
ASOS PROGRAMACIÓN - PROGRAMMING STEPS - ETAPES DE PROGRAMMATION
To program the connections bracket, it must first be made ready to receive the code. To do this, connect a monitor to the connections
bracket using the connecting strip, mount a receiver on the monitor (see steps 1 and 4 on page 18), and follow these steps:
For greater ease, you can lean the monitor against the connections bracket. To do so, fit the upper right-hand tab of the connections
bracket into the central slot on the base of the monitor.
Turn the PROG switch to the OFF position (2.1), the tone stops. Turn the switch back to the ON position (2.2).
Press the lock release button. The audio and the video will be activated between the monitor and the main panel. The monitor is
ready to receive the code.
From the main entrance panel, make the call to the house or flat when monitor to be programmed is installed. The panel emits a
confirmation tone. The connection bracket has been programed.
Check the operation of the monitor (call, audio and door opening). If the monitor does not function correctly then repeat the process
from Step 2.
Note: Maximum time limit of 1 minute between Steps 2 and 3 and between 3 and 4. The system warns by means of a series of beeps
of the end of the time limit between Steps 3 and 4; repeat Step 3 to have another minute. If the time limit is exceeded the process must
be repeated from Step 2.
D I G I TA L V I D E O D O O R E N T R Y S Y S T E M S
Tabla de contenido
