Installation; Connection Cable; Before The Installation; Built-In Hobs - Electrolux EHF6232FOK Manual De Instrucciones

Problem
comes on.
comes on.
and a number come on. There is an error in the hob. Disconnect the hob from
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also three
digit letter code for the glass ceramic (it is
in the corner of the glass surface) and an

8. INSTALLATION

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in units
WARNING!
Refer to Safety chapters.
Possible cause
Automatic Switch Off oper-
ates.
The Child Safety Device
function operates.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with a connection
cable.
• Replace the damaged mains cable with
a special cable (type H05BB-F Tmax
90°C; or higher). Speak to your local
Service Centre.
ENGLISH
Remedy
Deactivate the hob and ac-
tivate it again.
Refer to "Daily use" chapter.
the electrical supply for
some time. Disconnect the
fuse from the electrical sys-
tem of the house. Connect
it again. If comes on
again, speak to an Author-
ised Service Centre.
11