Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the
fan. To reduce the risk of fire or electrical shock, do
not use a full range dimmer switch to control the fan
speed. (Figure 1)
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
Do not operate this fan with a variable (Rheostat)
wall controller or dimmer switch. Doing so could
result in damage to the ceiling fan's remote control
unit.
3.
Remove the battery cover from remote control by
screwdriver and retain the screw for later. (Figure 3)
4. To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting
process. If not used for long periods of time, remove
battery to prevent damage to transmitter. Store the
remote away from excessive heat or humidly.
(Figure 4)
Chemical Burn Hazard. Keep batteries away from
children.
How to Operate Your Ceiling Fan
WARNING
WARNING
WARNING
For illustrative purposes only-not
intended to cover all types of controls
3V CR2032
Battery (2 pcs)
14
Figure 1
MAIN FUSE BOX
Figure 2
Figure 3
Figure 4
Capítulos
Tabla de contenido
Solución de problemas
