Setup Instructions - Polygroup RP800 Manual Del Propietário

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING:
CLIMBING HAZZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
1. Set up the pool by following all the instructions that came with the pool. Do not
fill with water until the Filter Pump is properly installed. Locate the
Outlet and Inlet openings on the pool wall.
Inlet
Outlet
3. Lubricate the RF Gasket with petroleum jelly (not included)
and install the Return Fitting
pool. DO NOT over tighten the RF Nut or wrinkle to pool liner
around the RF Gasket.
Outside Pool Wall
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
9

SETUP INSTRUCTIONS

on the Inlet opening of the
Inside Pool Wall
MST. Extended operating days and hours during peak season requirements.
2. Lubricate the SF Gasket with petroleum jelly (not included)
and install the Suction Fitting
DO NOT over tighten the SF Nut or wrinkle to pool liner around the SF
Gasket or the SF Washer.
Outside Pool Wall
4. Remove the Filter Pump Canister
Hose Clamps from the package.
on the Outlet opening of the pool.
Inside Pool Wall
, Hoses - , and