Polygroup RP800 Manual Del Propietário página 11

10. Air is now trapped inside the Filter Pump system, which will prevent
the water from flowing smoothly. To VENT the system (release the
trapped air), open the Vent Screw
turning it counter-clockwise. The water pressure will force out all
the trapped air inside the Filter Pump system. Tighten the Vent
Screw when you see water flowing out from the Seal Top
1. Plug the GFCI power cord to a properly grounded receptacle. It is recommended that the outlet is at least 15 feet (4.5m)
away from the pool.
2.
IMPORTANT: To start the filter pump, press the RESET button on the GFCI plug
3.
Check the return fitting on the inside of the pool for correct flow, it should feel like a solid stream of water returning to the
pool.
You can use the return flow as a gauge to determine when the filter needs cleaning or replacement. If you feel
a reduction in flow, clean or replace filter.
4. Test water and adjust as needed, read Page 13 - "POOL WATER CARE".
WILL NOT PREVENT ALGAE FROM GROWING IN POOL WATER; THIS CAN ONLY BE DONE BY MAINTAINING
PROPER CHLORINE AND pH LEVELS AT ALL TIMES!
5. The filter cartridge may need to be cleaned and/or replaced several times at start up until the correct chlorine and pH levels
are attained. We recommend that you keep at least one spare filter cartridge on hand at all times. Filter cartridges may
be purchased at the store you purchased your pool from, or ordered from Polygroup
6. To turn off the filter pump, press the test button and unplug the GFCI power cord
IMPORTANT! Your filter pump is protected by a thermal switch. The switch senses the temperature of the filter pump. If it gets too hot, the switch will stop the pump
from running until it cools off. To restart the pump press the reset button on the GFCI when the filter pump has cooled down. This is a safety device to prevent pump
damage and prolong service life. If your pump is automatically turning off, it is because of high pool water temperature and/or low water flow through the pump. If this
happens you need to check the water flow and correct it if needed, as this filter pump uses the water flow for cooling. It is recommended that you run the pump at
night or early morning when the temperature is lower to prevent overheating.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
11
at the top of the pump by
.
FILTER PUMP OPERATION
PUMP MOTOR PROTECTION
MST. Extended operating days and hours during peak season requirements.
11. Adjust the Return Fitting Diverter to maximize the circulation of
the pool water. (see picture below). It is recommended to point
the Return Fitting Diverter
suction or water intake for optimum pool circulation.
Inside Pool Wall
.
30
VERY IMPORTANT– FILTER PUMP ALONE
at polygroupstore.com.
®
.
30
down and away from the
How to use the GFCI plug
Press
"RESET"
Button
To Start
Pump
Operation
*Do not connect
to a timer device