Electrical Connection; Start-Up; Electronic Control Interface; Overview Of The Features - Tallas Pumps 720 W Instrucciones De Instalación Y Mantenimiento

7. ELECTRICAL CONNECTION

Ensure that the mains voltage is the same as the value shown on the motor plate and that there is the possibility
of making a good earth connection.
table 2.
The length of the power cable on the pump limits the installation distance, if an extension is required,
make sure that it is of the same type (e.g. SJTOW 16AWG o SJTW 15AWG depending on the installation)
see tab 2.

8. START-UP

Do not start the pump without having completely filled it with liquid, about 4 litres, until it comes out of the air
vent cap (2).
If the water supply is finished, take the plug out of the socket immediately and switch off the pump. Avoid dry running.
1. Before starting, check that the pump is properly primed, filling it completely, with clean water, through the filling
hole, after having removed the filling cap of the transparent filter (1), with your hands or with the appropriate tool
provided. At the same time open the vent cap (2) to let out the air. This ensures that the mechanical seal is well
lubricated and that the pump immediately starts to work regularly. Dry operation causes irreparable damage
to the mechanical seal.
2.
The filling cap must be screwed on accurately until it stops (1), as must the vent cap (2).
3.
Insert the plug of the power cable in a 115-120V power socket. Attention! The pump motor will start immediately,
the water will start to come out after a maximum time of 3 minutes, depending on the depth of the water level, in
the well or cistern.
4. The pump will continue to work and supply water. Attention! Avoid dry running.
5.
To switch off the pump, take the plug out of the power socket.
In case of problems with the priming, repeat the handling until all air in the suction is disappeared.

9. ELECTRONIC CONTROL INTERFACE

(A)

9.1 Overview of the features

Description
Controller board voltage, frequency
Power on/off indicator
Motor on/off indicator
Alarms indicator
Pressure indicator
Mode indicator
Auto Mode
Manual Mode
Dry-running protection
Anti-leakage
Max pump on protection
Cut-in pressure
Cut-out pressure
Auto priming
Selection buttons
 = Fixed;  = Selectable
ENGLISH
Follow the indications on the technical data plate and in this manual,
Parameters
1x115-120V, 60Hz









 (30 minutes)
Variable (22 – 44 psi)
 (Cut-in + 14.5 psi)


4
(B)
(C)