Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly
Installing Flexible Shaft
1.
Remove the bolt and insert the outer fitting (with
o-ring) into the joint pipe, and tighten the bolt.
2.
Insert the outer fitting into the clutch drum hous-
ing with pulling up the Pin. Be sure pin returns to
original position by spring and outer fitting never
comes off from clutch drum housing.
Bolt
Joint Pipe
Clutch Axis
Inner Shaft
Outer Fitting
Loop Handle Installation
The loop handle kit contains a package of four screws
and nuts and the bottom clamp for the loop handle.
Screw (4)
Nut (4)
1.
Place the loop handle and the bottom clamp on the
shaft approximately 11 inches (28cm) from the
end of the stop switch/throttle trigger assembly for
an initial handle position .
Outer
O-ring
Pin
Clutch Drum Housing
Loop Handle
Bottom Clamp
2.
Install the four screws and nuts. Leave the screws
fingertight.
3.
Reposition the loop handle up or down the drive-
shaft to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
stop switch.
4. Tighten the screws and nuts.
Connecting Stop Switch Wires
Matching Connector
Stop Switch
Wires
Plug the stop switch wires into the matching connectors
from the engine. Note that wire polarity is not
important.
— US-13 —
Knob
Air Filter Cover
Capítulos
Tabla de contenido
