Marmitek Invisible Control 6 XTRA Manual Del Usuario página 5

• Use the self-adhesive strip which is supplied to locate the IR receiver just about
anywhere you please.
• Experiment with the location before you stick the IR receiver in its final position.
Note! The sticky strip may lead to discolouration or leave glue residues on certain
surfaces.
4.2 LOCATING THE IR BLASTER LED
V
Stick the IR blaster LEDs (2) wherever you like in the cabinet or TV unit. You
will then be able to operate all of the A/V devices in that specific section.
• With a correct placement one blaster LED can control all A/V devices placed in the
same compartment.
• In some situations it is necessary to place a second blaster LED if not all A/V devices
can be controlled with one blaster LED.
• Or you place the blaster LED on one of the A/V devices in the middle of the cabinet
and the other equipment will be controlled as well by the reflection of the
infraredsignal.
4.3 LOCATING THE IR MODULE
Mount the IR Module (3) at an accessible place behind or alongside your A/V
equipment, in the vicinity of an electrical socket.
• Be aware of the cable length of the IR blaster LEDs and
the IR receiver.
• Make sure that the connections remain accessible and
that the 'IR data' light remains visible so you can check
it is working properly.
• Use the self-adhesive strip which is supplied to locate
the IR receiver just about anywhere you please.
INVISIBLE CONTROL 6 XTRA
2
TM
2
V
3