Marmitek Invisible Control 6 XTRA Manual Del Usuario página 4

3. HOW DOES IT WORK?
3
V
Locate your A/V device in a closed cabinet or TV unit. The IR receiver (1) must be located
in view of your remote control. Stick the IR blaster LEDs (2) wherever you like in the
cabinet or TV unit. You will then be able to operate all of the A/V devices in that specific
section. You can then place the IR modules (3) in discrete locations. Point the remote
control towards the small IR receiver in order to send the desired command (via the IR
module) to the IR blaster LEDs; these will then send on this infrared command to the
A/V equipment.
4. INSTALLATION
In order to check that the system works correctly, it is advisable to first test the set-up
you had in mind. To do so, connect everything as described below but do not stick the
components securely.
4.1 LOCATING THE IR RECEIVER
Place the very small IR receiver (1) that comes with the Invisible Control 6 XTRA™ so that
it can be seen by your (infrared) remote control and receive the commands (max. 10
metres).
• The most logical location for the IR receiver is, for example, on the cabinet in which
the A/V equipment is located or near the TV.
• You can run the cable underneath or behind, using the notch at the back of the IR
receiver housing; this allows the cable to be hidden easily.
4
1
2
1
2
1
© MARMITEK