Idiomas disponibles
Idiomas disponibles
WIRING
All wiring must comply with local and national codes
and unit must be properly grounded.
1. Run 120VAC, 60 Hz supply wiring to the wall switch (not
provided). The unit must be wired on a separate 20
Amp circuit.
2. Run wiring from the switch to the housing junction box.
Loosen screw holding exterior wiring compartment cover
and remove cover. Interior wiring compartment cover can
be removed if necessary by loosening screw in keyhole
slot in cover. Remove knockout(s) as required and install
approved box connectors.
3. Refer to Fig. 2. Connect white wires in junction box to
white (neutral) supply wire. Connect the black wire to the
supply wire from the light switch. Connect the red wire in
the junction box to the supply wire from the heat switch.
Connect green ground lead in the junction box to the
supply ground.
4. Replace wiring compartment cover and tighten screw to
secure.
5. Insert plug from heater assembly into the white receptacle
of the wiring compartment cover.
MOUNTING THE REFLECTOR AND
GRILLE
1. Place the reflector in the opening in the center of the grille.
The notches in the reflector should fit over the pegs on
either side of the opening. Insert plug from lamp socket into
black receptacle on wiring compartment.
2. Place 1" screw, provided, through the center hole in the
reflector and thread it into the hole in the mounting bracket
running across the housing. Tighten the screw just enough
to hold the grille firmly against the ceiling.
3. Install a 100 watt maximum, type A-19 light bulb.
LIGHT SOCKET
REFLECTOR
REFLECTOR
MOUNTING
SCREW
FIGURE 3
HEATER JUNCTION BOX
LIGHT RECEPTACLE
WHITE
WHITE
WALL SWITCH BOX
WHITE
BLACK
SWITCH SHOWN IS NUTONE
ACCESSORY SWITCH HS-92
120VAC LINE
4. Snap lens into position in center of grille. To remove the
lens for relamping, gently pry along the side of the lens with
a screwdriver to disengage the snap in tabs while pulling
down on the lens.
HEAT RECEPTACLE
(WHITE)
RED
BLACK
RED
LIGHT
HEAT
(SOLD SEPARATELY)
LENS
FIGURE 4
GREEN
SUPPLY
GROUND
FIGURE 2
