Assembly Of Handheld Remote Control - Craftmade Illusion ILU56 Guia De Instalacion

9. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 9 for
remote control assembly instructions. If you have
already installed the wall control but do not wish to
use the handheld remote control, please proceed to
Section 10.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was
not previously used)--use wire cutters to cut off
each wire as close to the wall control as possible.
[Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
Since this fan comes with an LED light kit, the
dimmer switch (labeled ON and D) has been
pre-set to the "ON" position (ON). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (D). [Refer to
diagram 2.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover
together until you hear a click at each end,
indicating that the remote control cover has
closed completely.
IMPORTANT: Store the handheld remote control
away from excess heat or humidity. To prevent
damage to handheld remote control, remove the
battery if remote control will not be used for
long periods.
diagram 1
dimmer
switch
diagram 2
post hole
remote control
cover, BOTTOM
diagram 3
page 8
remote
control
cover
(top)
(bottom)
wall control
wire
III IV
II V
VI
I
wire
wire
12V battery
hole
III IV
II V
VI
I
wall
remote control
control
post
cover, TOP