Tabla de contenido
®
R&S
Scope Rider RTH
Key
Press shortly
SHIFT opens a dialog to save and load
instrument settings.
If a dialog or menu is open, BACK closes it. If the menu is closed, the key
toggles the focus between focused element in the diagram and the Menu
button.
Open or close the "Mode", "File" or "Setup" dialog, respectively.
Saves measurement documentation:
Only screenshot if "one touch" is off. ZIP file
with selected data if "one touch" is on.
All R&S RTH:
The effect depends on the channel state:
If the channel is off, the key switches on the
channel and sets the focus. The key lights
up.
Only
If the channel is on but not in focus, the key
R&S RTH1004:
sets the focus. The key lights up.
Only
DMM starts or stops the meter measure-
R&S RTH1002:
ments (same as MODE = "Meter").
DMM REL enables or disables relative meter
measurements.
TIME and POS adjust the horizontal time scale and position of the trigger
point.
RANGE and POS set the vertical scale (vertical sensitivity) and the vertical
position of the focused waveform (analog or channel, math or reference
waveform).
Getting Started 1326.1561.02 ─ 05
Operating the Instrument
Accessing the Functionality
Press and hold
Press and hold for 2 seconds
to disable or enable the
touchscreen.
Opens or closes the "Screen-
shot" dialog to configure the
screenshot and the "one
touch" output.
Open or close the "Vertical"
dialog for the corresponding
channel to configure the
channel settings.
Opens or closes the "Meter"
dialog to configure the mea-
surements.
37
Tabla de contenido
