Troubleshooting - Franke FCB 360 NF NE F Manual De Uso Y Instalación

TROUBLESHOOTING

What to do if...
The control panel
is switched off, the
appliance does not
work�
The inside light does
not work�
The temperature
inside the
compartments is not
low enough�
There is water on
the bottom of
the refrigerator
compartment�
The front edge of
the appliance, at the
door striker seal, is
hot�
The red icon is
flashing and a sound
signal is activated
The red icon is
flashing, a sound
signal is activated
and the icon is
activated�
Possible reasons
The appliance may be in
On / Stand-by mode�
There may be an appliance
power supply problem�
The light may need to be
replace�
The appliance may be in
On / Stand-by mode�
There could be various causes
(see "Solutions")�
The defrost water drain is
blocked�
This is not a defect� It prevents
condensation from forming�
Door open alarm
It is activated when the
refrigerator and/or freezer
compartments door remains
open for a prolonged period
of time�
Blackout alarm
This activates when there
is a prolonged interruption
to the power supply which
has caused an increase in
temperature in the freezer
compartment�
Note: until the blackout alarm
is deactivated, you cannot set
a different temperature for the
product.
Solutions
Turn the appliance on pressing the On/Stand-by
button� Check that:
• there is not a power outage;
• the plug is properly inserted in the power socket
and the mains double-pole switch (if present) is in
the correct position (i�e� allows the appliance to be
powered);
• the household electrical system protection devices
are efficient;
• the power cable is not damaged�
Models with LED lights: contact the authorised
Technical Assistance Service�
Turn the appliance on pressing the On/Stand-by
button�
Check that:
• the doors close properly;
• the appliance is not installed near a heat source;
• the set temperature is adequate;
• the circulation of air through the ventilation of the
appliance is ensured�
Clean the defrosting water drain (see section
"Cleaning and Maintenance")�
No solution is necessary�
To turn the sound signal off, close the open door of
the product�
Before turning off the sound signal, it is
recommended that you pay attention to the
temperature shown on the temperature display,
corresponding to the highest temperature reached
in the freezer compartment during the power cut� To
turn the sound signal off, briefly press the "Turn off
sound alarm" button�
After pressing the button, the temperature display
will again show the temperature set� If the freezer
compartment has not yet reached the optimal
temperature for the preservation of the food, the
freezer compartment temperature alarm may activate
(see freezer compartment temperature alarm)� Check
the condition of the food before consuming it�
EN
13