Adjustments - Ryobi CSB142LZ Manual Del Operador

WARNING:
Before performing any adjustment, make sure the product
is unplugged from the power supply and the switch is in
the OFF position. Failure to heed this warning could result
in serious personal injury.
WARNING:
DO NOT point the laser at yourself or others. Class IIIa
lasers will burn the retinas and could cause serious injury
to the eyes.
WARNING:
Use of controls or adjustments or performance other
than those specified herein could result in hazardous
radiation exposure.
ADJUSTING THE LASER
See Figures 27 - 29, page 21.
The adjusting screw moves the laser beam laterally from left
to right. The laser can be realigned by adjusting the screw
located above the front of the upper blade guard.
The laser beam can also be realigned in a rotational direction
by adjusting the laser barrel.

ADJUSTMENTS

NOTE: Draw a pencil line on a scrap workpiece parallel to
the long edge of the base as a straight line guide to aid in
the adjusting process.
To adjust the laser laterally:
 Remove the blade.
 Plug in the saw.
 Turn laser on.
 Rest the front of the base on scrap workpiece.
 Adjust screw as necessary.
 Check for proper alignment.
 Repeat as necessary until laser is aligned.
To adjust the laser in a rotational direction:
 Remove the blade.
 Plug in the saw.
 Rest the back of the base on scrap workpiece.
 Insert a flat blade screwdriver into the laser barrel slot.
 Turn laser on.
NOTE: DO
 Turn the barrel left or right as necessary.
 Check for proper alignment.
 Repeat as necessary until laser is aligned.
NOTE: Since blade thicknesses vary, always make a trial cut
in scrap workpiece to ensure an accurate cut.
15 - English
NOT look directly into the laser beam.