URBANGLIDE SUV100 BT Manual De Instrucciones página 8

When using the product, if it has almost no battery, a beep will sound (the same as the
ignition). It will then load the product.
When the power is low, there is not enough power for normal driving, do not continue to
use the product, it is very easy to fall and it will also affect the life of the battery.
When you switch on the Segway, you will hear an audible signal, which means that the
warning devices, seen above, function correctly.
Sound alerts:
1 beep: normal operation on ignition.
2 beeps: Calibration error or misplaced user's weight, go down, turn off and on again.
Calibrate the product
1. Switch off the product. A beep will sound to indicate that the product is off.
2. Align the surface of the two flat pedals.
3. Press and stay press the button On/Off.
4. The battery indicator lights up first, stay pressed until the Segway beeps once,
then release the button.
5. The product is calibrated.
Load the product
1. Make sure the charging connector is clean and dry.
2. Start by plugging the switch into the power interface, then plug the other end of the
charger into the product.
3. When the red indicator lights up on the charger, it means that the charging is done
correctly, if it is not the case, check that the line is connected correctly.
4. When the LED on the charger changes from red to green, the battery is fully
charged. Stop loading. Charge time too long could affect the life of the battery.
7 /EN