Craftsman CMCN616 Manual De Instructiones página 12

English
Fig. E
16
Loading and Unloading the Tool (Fig. F)

WARNING: Keep the tool pointed away from yourself
and others. Serious personal injury may result.

WARNING: Never load nails with the contact trip or
trigger activated. Personal injury may result.

WARNING: The battery should always be removed
and the trigger lock-off engaged whenever any
adjustments are made or when tool is not in use.
To Load the Tool
1. Insert fasteners into the bottom of the magazine
2. Pull pusher back until the nail follower falls behind
the nails.
3. Release the pusher.

CAUTION: Keep fingers clear of pusher to
prevent injury.
To Unload the Tool
1. Press pusher latch release button
2. Manually slide nails towards the bottom of the
magazine 9 .
3. Open the jam clear door on the nosepiece to verify
there are no nails remaining. Refer to Clearing a
Jammed Nail.
Fig. F
9
11
10
All manuals and user guides at all-guides.com
9 .
11 .
Using the Nailer

WARNING: The contact trip needs to be depressed
followed by a full trigger pull for each nail followed
by a release of both the contact trip and trigger after
each nail.

WARNING: The battery should always be removed
and the trigger lock-off engaged whenever any
adjustments are made or when tool is not in use.
1. Fully depress contact trip against the work surface.
2. Fully pull trigger and motor will start. (nail will drive into
work surface).
3. Release trigger.
4. Lift contact trip off work surface.
5. Repeat steps 1 through 4 for next application.
Worklights (Fig. G)
There is a worklight 5 located on each side of the nailer.
Worklights turn on upon battery insertion, activation of the
trigger, or depressing the contact trip.
nOTE: These worklights are for lighting the immediate work
surface and are not intended to be used as flashlights.
lOW BATTERY inDiCATOR: The left-side worklight will
flash four consecutive times and then shut down to indicate
low battery.
JAMMED nAil inDiCATOR: The right-side worklight will
flash continually if a nail becomes jammed in the nosepiece
(see Clearing a Jammed Nail).
5
Fig. G
Stall Release (Fig. H)

WARNING: If a stall occurs, the tool will disable
itself and will require you to reset it. To do so, follow
instructions on clearing a stalled condition. Next
remove battery pack and then reinsert battery pack.
The tool will now be operational.
If the nailer is used in a rigorous application where all
available energy in the motor is used to drive a fastener, the
tool may stall. The driver blade did not complete the drive
cycle and the jam/stall indicator will flash. Rotate the stall
release lever 6 on the tool and the mechanism will release .
nOTE: The tool will disable itself and not reset until the
battery pack has been removed and reinserted. If the unit
continues to stall please review the material and fastener
length to be sure that it is not too rigorous an application. If
the driver blade does not automatically return to the home