Putting Into Operation; Troubleshooting; Cleaning, Maintenance; Warranty - Reer EasyHeat Manual De Uso

Putting into operation

1. Insert the mains plug into the power socket (fig. 1).
2. Pull the pull cord (fig. 2) to switch the heater on. The heater is then set to 500 W.
3. Automatic shut-off is directly activated. After 10 minutes, the device is automatically switched off or it may
be switched off at an earlier point by pulling the cord again.

Troubleshooting

issue possible causes
No heat radiation • The power plug is not connected
properly.
• The automatic switch-off function
(timer) is activated.
Heat radiation despite the
Defective LED
indicator being switched off.
10
10
remedial action
• Check the power plug.
• Turn the „Timer" to „Off" or switch
the unit off and then on again by
repeatedly pulling the pull cord.
Please contact the customer service

Cleaning, maintenance

• Before cleaning, ensure that the unit is switched off and cooled down (pull out the power plug). Clean the
surface with a dry, slightly damp cloth. The reflector and heating tubes must be cleaned by skilled personnel only.
• This product does not require any special maintenance.
• Repairs must be carried out by skilled personnel only.

Warranty

Please retain your receipt, the user manual and part number.
Claims under warranty or under warranty commitments are to be processed by the dealer alone.
The technical specification, information and characteristics of the product described herein have been compiled to
the best of our knowledge and belief and are correct at the time of printing. Any information provided by reer should
be correct and authoritative. Nevertheless, reer does not accept liability for potential errors in this document and
reserves the right to make changes to the product design and/or specifications without prior notice. Reproduction
and disclosure of information contained in this copyright-protected document, in any form or by any means - graphi-
cal, electronic or mechanical by photocopying, recording on tape or storage in a data retrieval system - even in part,
require prior written consent from reer.
Environmental protection
At the end of its life, this product must not be disposed of as normal domestic waste, but should
be recycled at a collection point for electrical appliances. Please see the relevant symbol on the
product, in the user manual and packaging. Materials can be recycled as specified. An important
contribution to the protection of the environment can be made by reusing the unit, recycling its
components or otherwise reusing old appliances. Please contact your local council to find out more
about an appropriate disposal centre.
11