Putting Into Operation - Reer FeelWell Manual De Uso

Putting into operation

1. Insert the mains plug into the power socket (fig. 1).
2. Pull the pull cord (fig. 2) to switch the heater on. The heater has two heat settings: 400 W (level „1") and 800 W
(level „2").
3 Pull the cord again to change the heat setting or switch the unit off (level „0").
1 2
230 V
Automatic switch-off function
1. To activate the automatic switch-off function, switch the timer switch on the
bottom of the unit to the „ON" position. The unit switches off automatically
after 10 minutes.
2. There are 2 ways of switching the unit on after automatic switch-off:
• Move the rocker switch to the „Off" position or
• pull the pull cord, until the heat setting indicator shows „0". If the pull
cord is pulled again on heat setting „1" or „2", the unit is switched on
again.
Switch-off if tilted
If the angle exceeds 25° (for example if the unit is mounted on the ceiling), the power supply to the unit is cut. The unit
switches back on automatically, when it is upright again.
Troubleshooting
issue possible causes
• The power plug is not connected properly.
No heat radi-
• The automatic switch-off function (timer)
ation despite
is activated.
heat setting
indicator
showing „1"
• The automatic tilt switch-off function is
or „2".
activated, because the angle of the heater
exceeds 25°.
I
O
TIMER ON
1
2
ON
400 W 800 W
I
O
TIMER ON
TIMER ON/OFF
TIMER ON/OFF
remedial action
• Check the power plug.
• Turn the „Timer" to „Off" or switch the unit
off and then on again by repeatedly pulling
the pull cord.
• Ensure that the heater is level and fixed to
the wall.
- 12 -
10
0
ON
OFF
10
TIMER OFF
TIMER ON/OFF
TIME
I
O