English
► Hold upper handlebar (2) against lower han‐
dlebar (3) so the bores align.
► Push bolts (4) through bores (5) from the
inside to the outside.
► Screw in quick-clamping devices (6) at
bolts (4) and fold upwards so quick-clamping
devices (6) are pressed tightly against the
handlebar.
► Press cable clips (7) onto the upper handle‐
bar.
► Insert cables (8 + 9 + 10) in cable clips (7).
► Close cable clips (7) and allow the tab to
engage.
► Fasten motorstop cable (8) to the upper han‐
dlebar on the left using cable clip (7), main‐
taining the distance a = 42 - 44 cm.
► Fasten self-propulsion cable (9) and Vario
drive cable (10) to the upper handlebar on the
right using cable clip (7), maintaining the dis‐
tance a = 42 - 44 cm.
► Insert Vario drive cable (10) in guide (11) on
the detent segment.
► Press self-propulsion cable (9) over it into
guide (11) on the detent segment.
26
7 Refuelling the Lawn Mower
► Press control bar for mowing (12) to handle‐
bar (13) and hold.
► Slowly pull starter handle (14) in the direction
of starter rope guide (15).
► Hook starter handle (14) into starter rope
guide (15).
► Release control bar for mowing (12).
► Re-attach the spark plug socket.
6.2
Adding Engine Oil
The engine oil lubricates and cools the engine.
The engine oil specification and capacity can be
found in the engine instruction manual.
NOTICE
■ The lawn mower does not contain any engine
oil on delivery. Starting the engine with no or
too little engine oil may damage the lawn
mower.
► Always check the engine oil level before
starting and if necessary top up.
► Add the engine oil as described in the engine
instruction manual.
7
Refuelling the Lawn Mower
7.1
Refuelling the Lawn Mower
NOTICE
■ The lawn mower may be damaged if the cor‐
rect fuel is not used.
► See the engine instruction manual.
► Stop the engine.
► Place the lawn mower on a level surface.
► Clean the area around the fuel tank cap with a
damp cloth.
0478-111-9656-A