Model 1813 | Owner's Manual |
Ignition | Piezo-Electric
!
WA R N I N G
IGNITION |
Do not lean over griddle
while lighting.
PIEZO -ELECTRIC
!
WA R N I N G
GRIDDLE OPERATING INSTRUCTIONS
If ignition does NOT
occur in 5 seconds, turn
For proper ignition and operation of the griddle follow the steps below.
burner controls OFF, wait
5 minutes and repeat
lighting procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner
and could accidentally/
inadvertently ignite with
risk of injury.
If ignition does NOT occur in 5 seconds, turn burner control OFF, wait 5
minutes and repeat lighting procedure.
For additional support, see youtube.com/blackstonegriddles
22
S T E P 0 1
Make sure LP tank is
properly connected to unit. Turn
gas ON at LP cylinder by taking 20
seconds to turn knob halfway.
S T E P 0 2
Push in control knob to
start gas flowing, then turn control
knob counter-clockwise to acti-
vate starter.
S T E P 0 3
Adjust temperature to
desired level.
TROUBLESHOOTING
Section 01
PIEZO-ELECTRIC IGNITION
TROUBLESHOOTING
SYMPTOMS
01. Burner will not ignite with piezo ignition system
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure. If this does not work, to deter-
mine the cause, please try to ignite your griddle with a match. (Please
reference the Match Lighting Instructions in the Cleaning the Burner
Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES
SOLUTION
01. Igniter wire misaligned.
Ensure that the igniter wire is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
02. Damage to the ignition system.
Contact customer service for replace-
ment parts.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES
SOLUTION
03. Burner tubes are not
Please reference the Gas Flow section of
receiving propane.
the Troubleshooting Chapter.
Troubleshooting
| Owner's Manual | Model 1813
23