EGO POWER+ CS1600 Manual Del Operador página 24

3. Position the chain saw on its side
on a firm,flat surface, so that the
tank cap is facing upwards. Rotate
the oil tank cap counterclockwise to
remove it (Fig. 8).
4. Carefully pour the bar and chain
oil into the tank. The filter in the
opening allows the oil to seep slowly
into the tank; be careful not to let
the oil spill from the opening. Fill to
the bottom of the fill neck. Wipe off any excess oil.
5. Replace the cap, place the saw upright, and view the level through the oil
inspection window. Oil should fill the window.
NOTICE:
◾ ◾
Use OREGON
low friction and faster cuts.
◾ ◾
Never use oil or other lubricants not specifically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature wear of
the bar and chain.
◾ ◾
Check the oil level frequently and fill when the oil level falls below the minimum
line. Never operate the chain saw if the oil is not visible.
◾ ◾
Do not use dirty, used or otherwise contaminated oils. Damage may occur to the
bar or chain.
◾ ◾
There is a filter inserted in the opening of the oil tank to filter out dirt and debris.
DO NOT remove the filter when filling the oil tank.
◾ ◾
It is normal for oil to seep from the saw when it is not in use. To prevent seepage,
empty the oil tank after each use, and then run the saw for one minute. When
storing the tool for a long period of time, be sure the chain is lightly lubricated;
this will prevent rust on the chain and bar sprocket.
◾ ◾
To preserve natural resources, please recycle or dispose of oil properly. Consult
your local waste authority for information regarding available recycling and
disposal options.
24
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1600
bar and chain oil for best results. It is specially designed to provide
®
8
Oil Tank Cap